If you want to showcase a fine wood species such as mahogany cedar or redwood a clear waterproofer is a good.
Best way to refinish a cedar deck.
Sand the entire deck with 80 grit sandpaper.
It is best to use a natural bristle brush if you are using an oil based product and a synthetic bristle brush with water based stains.
After the deck surface has been cleaned and rinsed down it should be allowed to dry.
Pump the sprayer until you feel resistance usually about 25 pumps or so.
On flat grained wood the surface should be scuff sanded with 50 60 grit sandpaper.
Mix a 50 50 solution of water and cleaner for reasonably clean wood or use the cleaner at full strength for extremely weathered boards.
Thompson s waterseal waterproofing stain there are lots of ways to refinish a deck.
Clean and neutralize the deck clean the deck using behr premium all in one wood cleaner.
Stir the mixture with a clean piece of wood and put the top back on.
The moisture content of the wood should be below 20.
It s usually best to stain seal the main deck surface with a paint pad applicator while paintbrushes are required for detail work.
You will likely need a few different brush sizes.
This procedure will greatly increase the coatings performance but will not detract from a smooth finish.
Use a palm sander and 80 grit paper to sand in corners and under rails where the larger machine won t fit.
Clean the wood before staining or sealing it is best to move on to staining and sealing very quickly after sanding.
For smooth planed flat grained cedar some surface preparation may be desirable.
You can also apply stain with a paint sprayer.
Many deck cleaners are concentrated and require additional water.
Experiment with a small area to determine which is best.
Then grab the wand and spray the solution on the deck surface photo 6.
The first step in refinishing a western red cedar deck is to clean it as above.
Surface preparation is not necessary for textured cedar.
Make sure that all surfaces are carefully vacuumed free of sanding dust then wipe the surfaces down with a tack cloth to remove all traces of dust before moving on to staining or sealing.
This is a good time to sand the railing with.